Metra Electronics DAT Combo Uživatelský manuál stáhnout pdf (Strana 3)

GMOS-LAN-09

• Connectthe16-pinharnesswithstrippedleadsintotheinterface.

• Connectthe14-pin,16-pinand20-pinharnessintothevehicle.

• Withallconnectionscompleted,reconnectthenegativebatteryterminal.

• Initializetheinterfacebyturningtheignitiononfor30seconds,thenturnthe

ignitionbackoff,thenbackonagain.

Note: If using the ASWC-1, connect it after you initialize the GMOS-LAN-09,

with the key in the off position.

Installing the GMOS-LAN-09

Connections to be made

(d) 12-pin pre-wired ASWC-1 harness:

• ThisharnessistobeusedinconjunctionwiththeoptionalASWC-1(not

included)toretainsteeringwheelcontrols.IftheASWC-1isnotbeing

used,disregardthisharness.Ifitwillbeused,pleaserefertotheASWC-1

instructionsforradioconnectionsandprogramming.

Note: Disregard the harness that comes with the ASWC-1.

To the aftermarket radio:

• ConnecttheRedwiretotheaccessorywire.

• PushtheOnStarbutton;theradioshouldmute,andyoushouldheartheOnStar

voice.PushtheOnStarcancelbutton;theradioshouldun-muteandplayagain.

Note: The radio will turn off instead if the mute wire is not connected.

Testing the GMOS-LAN-09

To the vehicle:

• ConnecttheGreen/Blackwireto Green/Blackwireintheblack,8-pin

connectorbelowthesteeringcolumn,onthebottomside.(FigureA)

Note: The relay attached to the GMOS-LAN-09 harness is only for audible turn

signal clicks. No extra steps are required to retain this feature, so leave the

relay as-is.

Connections to be made

(Figure A)

Green/Black wire

1 2 3 4

Žádné komentáře

Metra Electronics DAT Combo Uživatelský manuál Strana 3